A dimension is stated as Dia 25 H7 in a drawing. The lower limit is ?
The measured size of the dimension of a component is called
A pin is fitted in a hole. The tolerance zone of the pin is entirely above of that hole. The fit obtained will be
Interchangeability is normally applied for
Best example for shrinkage fit is
Why tolerances are given to the parts?
Which type of tolerance provided in drilling mostly?
Which of the following grade of a hole is mostly used for non-circular fits?
Which of the following option is incorrect for clearance fits?
What is the range of shafts which produce transition fits?
Which of the following grade is never used for fits?
Which of the following is not correct about plain gauges?
Dimension of one side of the inclined surface can be ______ projected on the reference plane.
If there are more than one inclined surfaces, then _________
If the surface contours are complicated then_______
Command to draw conveniently many construction lines at a specified angle is ________
Why tolerances are given to the parts?
What is bilateral tolerance?
Which type of tolerance provided in drilling mostly?
Which of the following is incorrect about tolerances?
What is the hardness of gauging portion in plain plug gauges?
Which of the following is not true for fixed gauges?
Up to which diameter, bar type plug gauges are used?
What is the suitable material for small plain plug gauges?
What is the range of size that can be checked by double-ended Rib type snap gauges?
