Full adder and Delay flip-flop from a serial adder(without effecting its operation) can be replaced by
Which of the following can be a frequency divider circuit?
The frequency of the pulse at R4 in the network shown below is Hz
An eight-bit binary ripple UP counter with a modulus of 256 is holding the count 01111111. What will be the count after 135 clock pulses?
The initial state of MOD-16 down counter is 0110. After 37 clock pulses, the state of the counter will be.
Assertion (A): Asynchronous sequential circuits are difficult to design.
Reason (R): External clock is used for synchronization of asynchronous sequential circuits.
Which of the following equations satisfies the j K flip-flop truth table?
The circuit given below is a
A 4-bit ripple counter and a 4-bit synchronous counter are made using flip-flops having a propagation delay of 10ns each. If the worst case delay in the ripple counter and the synchronous counter be R and S respectively then.
A master-slave flip-flop has the characteristic that -
Which of the following measurements can be done using a counter?
1. Pulse duration
2. Interval between two pulses.
3. Amplitude of the pulse.
4. Rise time of pulse.
Select the correct answer from the codes given below.
In a sequential circuit, the output at any instant of time depends.
The character equation of the T flip-flop is given by.
Consider the following statements regarding registers and latches.
1.Registers are temporary storage devices, whereas latches are not
2. A latch employs cross-coupled feedback connections.
3. A register stores a binary word, where as a latch does not.
The correct statement is/are.
Statement 1: A flip-flop is a bistable multivibrator.
Statement 2: A flip-flop remains in one stable state indefinitely until it is directed by an input signal to switch over to the other stable state.
